rick440
Adventure One
- Joined
- Jul 6, 2012
- Messages
- 955
- Reaction score
- 449
On my O-320-D3G, I discovered an oil leak coming out of the 1/2 inch bolt/nut on the pilot side of the engine. There are two of these that are in front of the #2 cylinder. The lower one is dropping some oil on the starter and then atomizes the oil spray onto the alternator and muffler shroud.
The 1/2 stud comes out of the engine block in which there is a spacer and then the bolt. Has anyone run into an oil leak there....and if so, what the repair options are? Photos below.
Much thanks!
The 1/2 stud comes out of the engine block in which there is a spacer and then the bolt. Has anyone run into an oil leak there....and if so, what the repair options are? Photos below.
Much thanks!
Last edited:
