ready1998
Well-Known Member
- Joined
- Aug 29, 2013
- Messages
- 265
- Reaction score
- 44
Hello Everyone.
Last weekend, on roll out after landing, the plastic on my throttle quadrant showed its age and its scorn for the cold by breaking in three even pieces between the Throttle, Prop Control, and Mixture:
From their condition you can see they were long in the tooth to begin with. The "Mixture" is still attached to the quadrant with a screw and hope.
The levers themselves are difficult to move and likely need some lube so I wouldn't mind replacing the whole thing. Is there a kit I can buy to have my A&P replace the entire quadrant? Or can I just buy this plastic?
Thank you all as always,
Bill
Last weekend, on roll out after landing, the plastic on my throttle quadrant showed its age and its scorn for the cold by breaking in three even pieces between the Throttle, Prop Control, and Mixture:
From their condition you can see they were long in the tooth to begin with. The "Mixture" is still attached to the quadrant with a screw and hope.
The levers themselves are difficult to move and likely need some lube so I wouldn't mind replacing the whole thing. Is there a kit I can buy to have my A&P replace the entire quadrant? Or can I just buy this plastic?
Thank you all as always,
Bill
Last edited:
