My PA 32 sat for better than a year while work was performed on it. The tanks were drained to comply with SB1006
It sat with the tip tanks empty. When I finally added fuel in the tip tanks the left one continues to read zero.
Voltage at the sending unit reads 5 volts. This is with out disconnecting the wires. I also have not checked the other tank sending unit to see what it reads. Maybe tomorrow.
Any suggestions?
Thanks
It sat with the tip tanks empty. When I finally added fuel in the tip tanks the left one continues to read zero.
Voltage at the sending unit reads 5 volts. This is with out disconnecting the wires. I also have not checked the other tank sending unit to see what it reads. Maybe tomorrow.
Any suggestions?
Thanks