I finally decided to move forward with an EDM-830 engine monitor in my Archer II. Will it fit in the #2 CDI location in landscape orientation near the radio stack without elogating the mounting hole and without going over the silver line? It appears that it would fit based upon the outline drawing and my measurements, but I wanted to make sure because I saw an issue in an Arrow fit thread. It appears there is more space in this location on an Archer II. Any pics one the EDM-830 installed in the Archer II?
Second question- Can I config the display so that it shows RPM and GPH in the arc areas? I rather have GPH than MAP in an arc area.
I was planning on moving up the CDI in the #2 location to the #1 location because the stec Alt hold indicator limits space in the #1 location.
Second question- Can I config the display so that it shows RPM and GPH in the arc areas? I rather have GPH than MAP in an arc area.
I was planning on moving up the CDI in the #2 location to the #1 location because the stec Alt hold indicator limits space in the #1 location.
