Bluerooster
Well-Known Member
- Joined
- Nov 29, 2015
- Messages
- 1,885
- Reaction score
- 614
And I'm a little spooked about the cost. In addition to the usual items, there were motor mounts, control yoke u-joint, fuel level sender, and the rod that connects the lower cylinder baffle front to rear. I did all the work, but the parts cost is an unknown as yet. But anyway, annual is almost done. Just waiting on a reamer for the tapered pin on the u-joint. I have a couple tapered reamers, but too large, and wrong taper anyway.