Piper Forum > Piper Models > Cherokee > A question for flat panel folks.
Help Support Piper Forum by donating using the link above or becoming a Supporting Member.
Reply
 
Thread Tools
Old 08-13-2017, 03:23 AM   #1
hish747
Established Member
 
hish747's Avatar
 
Join Date: May 2015
Posts: 95
Liked 5 Times on 5 Posts
Likes Given: 3

Default A question for flat panel folks.

When adding a flat aluminum (or plastic, kydex etc) overlay to replace the old plastic beveled overlay, how to you deal with the raised screw receptacles like the ones shown in the picture?


IMG_3632.jpg  
hish747 is offline  
 
Reply With Quote
Old 08-13-2017, 03:59 AM   #2
Orest @ CYFD
Administrator
PiPe_ADMIN.png
 
Orest @ CYFD's Avatar
 
Join Date: Feb 2012
Posts: 4,865
Liked 1150 Times on 930 Posts
Likes Given: 711

Default

You just put them back in. The panel is structural. It is an industrial look.

You can also laser bevel the screw hole openings, and use flat top screws.

* Orest
__________________
PA28-236 Dakota
C-FCPO
Orest @ CYFD is offline  
 
Reply With Quote
Reply


Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Hello folks! WarEagle Introductions 4 10-26-2016 11:01 PM
28-180 folks chime here please jpwamt Cherokee 10 07-21-2015 04:12 PM
JimC/Other memphis folks bartmc General Piper Discussion 3 08-23-2012 04:58 AM
Flat tire TEG916 General Piper Discussion 21 02-04-2012 09:05 PM
Cherokee annual average flat rate cost Riq Cherokee 41 09-16-2011 07:51 PM

This forum is provided for entertainment purposes only. Piperforum.com is not affiliated or endorsed by Piper Aircraft Inc. or its subsidiaries.


Newest Threads

LATEST SPONSOR DEALS